About this dashboard
What it estimates, where the numbers come from, and how to read them.
What it estimates
The dashboard puts two independent estimates side by side for every state and every year. The first is the feed resource available — what the country's crop and by-product stream physically yields as animal feed. The second is the feed requirement — what the livestock population needs in order to be maintained and to produce. The difference between them is the surplus or deficit for that state and year.
Both sides are reported twice. On a fresh basis they are physical tonnage of Dry Fodder, Green Fodder and Concentrate. On a nutrient basis they are Dry Matter, Crude Protein and Total Digestible Nutrients. Every figure on the site is in Million Tonnes.
The three feed classes
Crop residues — straw, stover, husk and haulms left after harvest. Bulky and cheap, close to 90% dry matter by weight, but low in protein.
Typical sourcesPaddy, wheat, maize, sugarcane tops, bajra, gram
Fresh forage and green tops, plus what grazing land and forest area yield. Mostly water, so a very large tonnage converts to modest dry matter.
Typical sourcesFodder crops, forest area, permanent pasture, tapioca
Grains, brans, oilcakes and DDGS. A small tonnage that carries a disproportionate share of the protein and the digestible energy.
Typical sourcesPaddy and maize grain, wheat bran, groundnut and coconut cake
A crop is not tied to one class. Paddy leaves straw that counts as Dry Fodder and grain that counts as Concentrate, so it appears under both — that is what the source file records. The DF / GF / Concentrate Detail page lists every crop under each class with its exact share.
The nutrient terms
- DM — Dry Matter.
- Feed with all moisture removed. The common yardstick: 1 tonne of green fodder and 1 tonne of straw are not comparable until both are expressed as DM.
- CP — Crude Protein.
- Total protein in the feed, estimated from its nitrogen content.
- DCP — Digestible Crude Protein.
- The fraction of that protein the animal can actually absorb.
- TDN — Total Digestible Nutrients.
- The energy value of the feed, as the weight of digestible nutrients it supplies.
Requirement scenarios
Requirement is not a single number. Each scenario scales it by applying a percentage to two livestock groups and summing the result.
Livestock yielding milk, meat, eggs or fish — milch animals (crossbred and indigenous cattle, buffalo in lactation plus maintenance), meat animals (male cattle, male buffalo, sheep, goats, pigs), poultry (broiler and layer) and fish.
All remaining livestock — draught animals, young stock, dry (non-lactating) females, and other categories not directly contributing to milk, meat, egg or fish output.
Example: “90% Productive + 50% Non-productive” applies 90% of the full productive-group requirement and 50% of the full non-productive-group requirement, then sums them. Total (100% + 100%) is the full national herd.
All 11 scenarios in the data
- Total (100% Productive + 100% Non-productive)
- 100% Productive + 60% Non-productive
- 100% Productive + 50% Non-productive
- 100% Productive + 30% Non-productive
- 90% Productive + 80% Non-productive
- 90% Productive + 50% Non-productive
- 90% Productive + 30% Non-productive
- 80% Productive + 70% Non-productive
- 80% Productive + 60% Non-productive
- 80% Productive + 50% Non-productive
- 80% Productive + 30% Non-productive
Data sources and coverage
- Availability —
Statewise_Cropwise_Feed_Nutrient_Detail - One row per year, state and crop, carrying each feed class's own tonnage and its own DM, CP, DCP and TDN. Because those columns exist per class, the composition split shown across the site is measured, not modelled.
- Requirement —
Statewise_DF_GF_Conc_Reconciliation - One row per state, scenario, year and metric. DF, GF and Conc are tonnages; DM, CP and TDN are whole-diet totals taken from the workbook's Requirements row. This file holds no per-feed nutrient columns, so on the requirement side only the tonnage split is a real percentage — and the site says so wherever that matters.
Excluded for having no requirement data: Ladakh, Maharashtra, Telangana.
Excluded for having no availability data: Dadra And Nagar Haveli.
Selecting such a state on its own still shows whichever figures exist for it.
What is validated, and what is not
The DM, CP and TDN values are validated and aligned with established nutritional standards and feed-evaluation benchmarks. The physical requirement estimates for Dry Fodder, Green Fodder and Concentrate remain under scientific validation and methodological refinement — read those three figures as provisional.
Two smaller points the pages surface where they arise: summing each class's nutrient columns lands a few hundredths away from the file's own total columns, because the source stores every class to two decimal places; and DDGS closes the concentrate tonnage exactly but has no nutrient columns of its own, so its DM, CP and TDN show as “—” — unknown rather than zero.
The data behind every chart
Each page is drawn from api.php,
which returns plain JSON. The endpoints are open — open one to read the exact numbers
behind a chart.